|新168幸运飞飞艇

Luster

Lusterless

Theoretical spreading rate

270g/m2, 4.93m2/L (calculated by 70μm dry film, excluding loss)

Specific gravity:

About 1.33

Drying time

23±2℃: surface dry ≤2h, hard dry≤8h

Flash point

38℃

Storage period

12 months

Construction Instruction

Mixing ratio

Single canned

Maturing time

Ready to use when being opened and stirred.

Service life

Unlimited

Construction method

High pressure siphon spray, air spray, manual brushing, roller painting.

Diluent

Diluent for X-14 chlorinated rubber coating

The largest amount of dilution

High pressure siphon spray

Air spray

Manual brushing, roller painting

5%

10%

3%

Spray orifice

0.4~0.5mm

2.0~2.5mm

_

Spray pressure

15~20Mpa

0.3~0.4 Mpa

_

Tool washing

Diluent for X-14 chlorinated rubber coating

Film coating thickness

Wet film: 200μm, dry film:80μm

Coating interval

Surface treatment

*If directly applying to the steel surface, Surface of the steel shall be treated with shot-blasting or sand-blasting to reach Class Sa 2.5 of Swedish de-rusting standard.

*Surface coated with Workshop primer needs second rust removal to reach Class St 3 of Swedish de-rusting standard.

*When the paint is used for large scale replacement and maintenance, steel plate shall be derusted by sand blasting to reach Class Sa 2.5 of Swedish de-rusting standard, as for small scale replacement and maintenance, steel plate shall be derusted by manual de-rusting to reach Class St 3 of Swedish de-rusting standard.

Construction condition

Substrate temperature shall be more than dew point above 3℃, relative humidity shall be less than 85%;

Prior primer

Zinc-rich epoxy primer, epoxy zinc powder Workshop primer, epoxy iron red Workshop primer, inorganic zinc silicate Workshop primer, also directly apply to the steel by rust removal.

Finishing paint

Chlorinated rubber boat topping paint, chlorinated rubber topside paint, chlorinated rubber deck paint, chlorinated rubber finish, acrylic acid finish and high chlorinated polyethylene enamel.

Packing Specification

Container of 20 liters can load 20kg.

Safety guide

Avoid inhaling solvent vapors and painting mist for long term, skin and eye may not contact with the product.

Forced ventilation shall be provided when applying the paint in confined spaces or stagnant air, although in good ventilation, protection tools shall be worn.

Annotation

＊Above-said thickness of dry film and wet film refers to the index while implementing the high-pressure siphon spray;

＊Relevant data in this instruction is obtained from laboratory, the actual product may be slightly different from it;

＊If above data is changed, the data is based on the latest instruction, without prior notification.